搅拌式风力致热装置启动性能研究

搭建搅拌式风力致热试验台,以自制的2种致热器为研究对象,使其分别在3个不同平均角加速度24.92、14.66、8.04 rad/s2下启动。通过动态扭矩测试仪和数据采集仪测试记录致热器启动阶段的相关数据。结果表明:致热器启动时所需扭矩与角加速度的一次方、转速、叶片半径的二次方成正比,同时得出这些因素之间的关系式;满负荷时,启动扭矩会出现一个峰值,且角加速度越大峰值越大,自然风必须提供峰值以上的扭矩,否则装置无法启动。     

高温气冷堆舱室抗商用飞机撞击的耦合数值分析

本文建立了大型商用飞机撞击典型高温气冷堆核电站反应堆舱室的非线性有限元模型，计算中混凝土舱室直接采用工程用钢筋混凝土的损伤塑性本构模型，飞机结构采用Johnson-Cook本构模型。对飞机高速撞击高温气冷堆核电站反应堆舱室非线性撞击过程进行模拟计算，得出正面和侧面撞击条件下的撞击载荷曲线、撞击位移云图、反应堆舱室混凝土破坏情况等结果。评估表明，反应堆舱室结构在撞击条件下的整体损伤微小，可为保护内部关键设备提供重要的屏障功能。     

Stochastic analysis of strongly non-linear elastic impact system with Coulomb friction excited by white noise

The stochastic response of frictionally damped strongly non-linear elastic impact oscillator subjected to white noise excitation and its stochastic bifurcation are considered. By the stochastic averaging method based on generalized harmonic function, one can obtain the stationary probability density function of this system. The effects of system parameters on the responses are investigated and the analytical results were verified by comparing with numerical results from Monte Carlo simulations. Stochastic bifurcations are discussed through a qualitative change of the stationary probability distribution, which indicates that the coefficient of friction, damping constant of the elastic impact force respectively, can be treated as bifurcation parameters.     

风洞模型加速度负反馈振动主动控制方法研究

针对尾撑式风洞模型强方向性振动问题,基于异位配置加速度负反馈控制器对风洞模型振动主动控制方法进行研究。首先,通过模态分析得到系统低阶模态振动的强方向性并基于系统特性设计了具有结构耦合性的内嵌压电陶瓷作动器的风洞模型振动主动控制系统。然后,基于异位配置NAF控制器分别设计了针对第二阶模态和前两阶模态的单模态NAF控制算法和双模态NAF控制算法。最后,进行了实验验证,结果表明:双模态NAF控制算法控制效果较好,前两阶模态阻尼比分别提高近13倍和近40倍,镇定时间分别缩短近11s和近26s。     

Radon and moisture impacts from interventions integrated with housing energy retrofits

Energy retrofits can reduce air exchange, raising the concern of whether indoor radon and moisture levels could increase. This pre/post-intervention study explored whether simple radon interventions implemented in conjunction with energy retrofits can prevent increases in radon and moisture levels. Treatment homes (n = 98) were matched with control (no energy retrofits or radon intervention) homes (n = 12). Control homes were matched by geographic location and foundation type. t-tests were used to determine whether post-energy retrofit radon and moisture level changes in treatment homes significantly differed from those in control homes. The radon interventions succeeded in preventing statistically significant increases in first floor radon using arithmetic (p = 0.749) and geometric means (p = 0.120). In basements, arithmetic (p = 0.060) and geometric (p = 0.092) mean radon levels statistically significantly increased, consistent with previous studies which found that basement radon levels may increase even if first floor levels remain unchanged. Changes in infiltration were related to changes in radon (p = 0.057 in basements; p = 0.066 on first floors). Only 58% of the change in infiltration was due to air sealing, with the rest due to weather changes. There was no statistically significant association between air sealing itself and radon levels on the first floor (p = 0.664). Moisture levels also did not significantly increase.     

Accuracy of wind energy forecasts in Great Britain and prospects for improvement

The metric representing the wind energy forecast error, when reported as a percent, is calculated quite differently than the error metrics for electricity transmission, electricity load, or in other industries such as manufacturing when they are also reported as a percent. The resulting calculated metric is quite different from what would be reported if the method utilized elsewhere was employed. This paper examines the possible forecast assessment and operational challenges associated with this finding. Concerning the prospects for improvement, the errors reported in MW of energy have a systematic component. With this insight, we developed a model to improve accuracy.     

Economic Evaluation of Power System Flexibility by Commercial Air Conditioner Control with Large Penetration of Photovoltaic Generation

High penetration of intermittent renewable energy such as photovoltaic (PV) and wind power could cause shortage of power system flexibility. Demand response is expected to help supply ancillary service instead of the conventional power plant. Commercial air conditioners are a promising responsive load for demand response because they account for a large proportion of power consumption in the power system. We calculate a system operation cost and hourly operation pattern of each power plant by using the optimal power generation model considering flexibility supply from controlling commercial air conditioner. We obtained the following results as an effect of commercial air conditioner control. (1) The power generation of oil fired power plants decreases at peak time and annual fuel cost of oil fired plant is reduced by approximately 30% at most in Kanto area. (2) The percentage of rated operation mode of LNG combined cycle plants increases. (3) Curtailed energy rate of PV decreases because a power storage amount by pumped hydropower generation increases. (4) Required battery capacity to reduce PV curtailed amount decreased by combining battery energy storage system in case of high penetration of PV.     

析晶污垢生长影响因素概述

结垢问题存在于各个行业,尤其在油田表现更甚。但材料表面特性对油田采出水中析晶污垢的影响并没有得到太多关注。主要对影响析晶污垢生长的三种主要表面特性因素进行简要综述。     

What is the future of solar energy? Economic and policy barriers

The most important characteristics and limitations of solar energy were reviewed in this study. The analysis of different aspects indicated that the most important global challenges of solar energy development were climatic challenges, technical constraints, and unwillingness to make investments. After describing current conditions and predicting the future of solar energy, this study analyzed the policies formulated by developed countries to develop this from of energy. Accordingly, China has gotten ahead of other countries in this industry due to the technological production of solar panels and governmental supports. Finally, the economic estimation of solar energy was presented by dealing with the economic barriers to this form of energy in developed countries. According to the significant growth in the reduction of solar energy electricity production cost, this source of energy can be used as a major source in the future. It was then recommended to use a hybrid of solar energy with other sources such as wind to reduce the costs.